How to treat the waste gas generated by the Baorui Titanium equipment vacuum pump?

How to treat the exhaust gas generated by the vacuum pump? The vacuum pump in the factory will volatilize a part of the exhaust gas. In fact, the vacuum pump itself will not generate exhaust gas. The exhaust gas discharged from the vacuum pump is mainly the gas component used in the working system. How to treat this part of the exhaust gas is simple and direct and the investment is small. It is the use of carbon adsorption to collect and purify the discharge. The adsorption characteristics of the activated carbon can be used to adsorb harmful components to the gas, so as to achieve a good effect of purifying the air. This article is controlled by Henglan Environmental Protection. Two ways to use.

vacuum coating machine,pvd coating machine,pvd vacuum machine,vacuum ion coating machine,multi-arc ion coating machine

The exhaust gas generated by the vacuum pump is not unique. The two methods are used to make the organic waste gas be purified by equipment after being collected, and then discharged to the atmosphere through the 15-meter chimney.

How to treat the exhaust gas generated by the vacuum pump?

The high-pressure generator is used to form a low-temperature plasma, and under the action of a large amount of electrons having an average energy of about 5 eV, the organic waste gas molecules such as benzene, toluene and xylene passing through the purifier are converted into various active particles, and combined with O2 in the air to form H2O. Low-molecular and harmless substances such as CO2 can purify the exhaust gas. During the process, when the organic gas enters the cold ion reaction chamber, the gas is evenly distributed to the plasma reaction chamber (PRC). The reaction chamber is divided into 149 hexagonal tubes, each having a coronal wire in the center, separated from the reaction chamber.

vacuum coating machine,pvd coating machine,pvd vacuum machine,vacuum ion coating machine,multi-arc ion coating machine

The high pressure line is used to conduct the reaction chamber to regulate the high pressure, and the high voltage is conducted to the tubular wire in the tube. A discharge phenomenon occurs from the wire to the tube wall. Once discharged, the plasma electrons collide with the gas molecules to produce chemically active nuclides, commonly known as radical and load carriers. In addition, it also has the function of a miniature electrostatic precipitator that can remove dust.

It is mainly composed of an activated carbon layer and a support layer. Activated carbon has developed voids, large specific surface area, and high adsorption capacity. It is precisely because of this characteristic of activated carbon that it is widely used in the deep treatment of water, such as domestic water supply, deep treatment of water in the latter stage (clean water). After using activated carbon for a period of time, it adsorbs a large amount of adsorbate, gradually becomes saturated, loses its working ability, and will penetrate the filter layer in severe cases. Therefore, regeneration or replacement of activated carbon should be carried out.

vacuum coating machine,pvd coating machine,pvd vacuum machine,vacuum ion coating machine,multi-arc ion coating machine

The above describes two methods for treating the exhaust gas of the vacuum pump. In fact, there are still many methods, mainly the pipeline collection of the vacuum pump exhaust gas. It is necessary to design the diameter of the main pipeline, the diameter of the branch pipe, etc., and then adopt the side suction or the upper side. Suction to collect problems, choose how much air volume and how much wind pressure fans, these are the decision to purify, if your vacuum pump exhaust emissions need to be purified, please contact us.